Inspection and Cleaning
Visual inspection, filter and fan checks, and cleaning of STS cabinets.
ALLIED CONTRACTORS · HOUSTON & DALLAS
A static transfer switch moves critical loads between two power sources in a fraction of a cycle. Allied Contractors maintains and tests STS units so that transfer happens when a source fails.
REQUEST A QUOTE →
THE SERVICE
Static transfer switches use solid-state switching to transfer load between two UPS sources, usually in about a quarter cycle. They protect single-corded IT equipment and loads that cannot tolerate the interruption of a mechanical transfer switch.
Because an STS sits directly in the critical path, a failed component or wrong setting can drop the very load it is meant to protect. Allied Contractors provides inspection, preventive maintenance, transfer testing, thermal imaging and replacement for STS units in data centers and critical facilities.
STS work is coordinated with UPS maintenance and PDU and RPP service, and with the manufacturer where firmware or warranty work is needed.
WHAT WE DO
Visual inspection, filter and fan checks, and cleaning of STS cabinets.
Power connections checked and torqued during maintenance bypass.
Manual and simulated-failure transfers between sources, with timing and alarms verified.
Review of source preference, voltage and frequency windows, and alarm reporting.
Infrared inspection of connections and power components under load.
Component replacement with the manufacturer and full STS replacement at end of life.

TECHNICAL CONSIDERATIONS
Maintenance on a static transfer switch has to keep the critical load supported the whole time.
PLANNING THE WORK
Every STS visit starts with a written method of procedure approved by your team.
Confirm sources, loads, bypass design and manufacturer requirements.
Place the load on bypass, perform maintenance and inspection, then return to normal.
Run transfer tests and record results and recommendations.
WHERE WE WORK
Data centers and colocation facilities with single-corded IT loads, telecom and network hubs, control rooms in manufacturing and utilities, and hospital IT and imaging systems.
We serve critical facilities in Houston, Dallas–Fort Worth, Austin and San Antonio.

WHY ALLIED CONTRACTORS
Allied Contractors, LLC is a Texas commercial and industrial electrical contractor founded in 2019, with offices in Pasadena (Greater Houston), Dallas and Schulenburg and crews serving Houston, Dallas–Fort Worth, Austin and San Antonio.
FREQUENTLY ASKED QUESTIONS
A static transfer switch uses solid-state electronics to transfer a load between two power sources, usually two UPS systems, in a fraction of a cycle so connected equipment keeps running.
An ATS is mechanical and typically switches between utility and generator power with a short interruption. An STS is electronic, switches between two conditioned sources and is fast enough that most IT equipment does not notice.
Most facilities perform STS preventive maintenance annually, with thermal imaging and more frequent checks based on condition, the manufacturer and your maintenance program.
Yes. Most units have a maintenance bypass. We follow an approved method of procedure so the load stays powered.
Yes. Where controller, firmware or warranty work requires the manufacturer, we coordinate and support them on site.
RELATED ELECTRICAL SERVICES
LET'S DISCUSS YOUR FACILITY
Tell us your STS models and how they are fed. Allied Contractors will propose a maintenance and testing plan that keeps your load protected.